TRAINING PRACTICAL INTERNAL CORROSION CONTROL AND MONITORING IN OIL & GAS OPERATIONS

TRAINING PRACTICAL INTERNAL CORROSION CONTROL AND MONITORING IN OIL & GAS OPERATIONS

Training Praktik Pengendalian Dan Pemantauan Korosi Internal Dalam Operasi Minyak & Gas

Training Internal Corrosion Control As A Key Factor To Pipeline Integrity Management

Internal Corrosion Problems in Gas, Oil and Produced Water Pipeline and Equipment

* Piping and Pipeline Leakage due to Pitting Corrosion and Microbiological Induced Corrosion
* Severe Pipe Wall Thickness Reduction and Short Remaining Service Life caused by Sour Corrosion
* Pipe Wall, Rotating Parts and Equipment Cracking due to Chloride and Sulfide in the Fluids
* Internal Corrosion of Pipeline and Equipment due to Water in Oil and Oil in Water Emulsions
* Internal Corrosion due to Multi Phase Flow in the Pipeline
* Severe Corrosion Rate caused by CO2 and Hydrate in the Gas Lines, CO2/H2S Removal Unit and Glycol Dehydration Unit
* Internal Corrosion in the Water Lines due to Dissolved Oxygen, Mud and Sludge
* Malfunction of Pump, Compressor, Valves and Equipment due to Under-Deposit Corrosion, Under-Film Corrosion and Fouling

The Nature, Mechanism and Characteristics of Internal Corrosion and the Control Methods

* Anodic-Cathodic Reactions, Electrical Properties and Characteristics of Corrosion Cells
* Physical & Metallurgical Conditions of Metals and Chemical Composition that Promote Corrosion
* Destructive and Catastrophic Effects of Corrosive Agents and Microorganism in the Gas, Oil and Produced Water Fluids
* The Role and Mechanism of O2, CO2, H2S, Dissolved Salts and Microorganism in Internal Corrosion
* The Role of Oilfield Bacteria and the Mechanism of MIC
* Characteristics and Detection of Internal Corrosion in the Pipeline and Surface Equipment
* Removal of Dissolved Corrosive Agents and Non-Hydrocarbon Gases in the Gas, Oil and Produced Water Fluids
* Internal Corrosion Control with On-line Chemical Inhibitors Injection, Surface Barriers and Scavengers

Internal Corrosion Detection and Monitoring Techniques, Devices and Analysis

* Visual Inspection and Early Detection Techniques & Devices for Monitoring Fluid Corrosiveness and Tests for Identifying Corrosion products
* The Important of Internal Corrosion Rate Monitoring Before and After Chemical Injection and Treatment
* NACE Standard Method for Preparation, Installation, Laboratory Analysis and Interpretation of Results of Internal Corrosion Monitoring
* Access Fittings, Retrievers, Corrosion Coupons, Scale Coupons, Corrosion Probes, Holders, Injection & Sampling Devices and Instrument for On-line Internal Corrosion Monitoring
* The Use of Nipple or Spool, Hydrogen Probe and Galvanic Probe
* NACE Standard Method for Testing and Analysis of Bacterial Activity and Microbiological Induced Corrosion
* Iron Content Analysis of Produced Water and the COPRA Correlation
* Down-hole Tubing or Casing Calipers, Ultrasonic Wall Thickness Testers and Radiography

Internal Corrosion Control with Chemical Inhibitor Injection, Passive Film Formation and Biocides

* Nature & Classification of Inhibitors and Effect of Ionic Character on
* Inhibiting Ability
* Formulations of Oilfield Inhibitors and the use of Water Soluble Inhibitors, Volatile Inhibitors and Acid Inhibitors
* Typical Corrosion Inhibitors, Scavengers & Biocides for Oil & Gas Field
* Guidelines of Inhibitor and Biocide Applications and the Chemical Injection Equipment for Pipeline and Surface Facility
* Inhibitor and Biocide Batch Treatment Using Pigs, Chemical Dosage and the Pigging Operations
* Surfactant and Cleaners for Solving Fouling Problem in the Equipment and Systems
* Cationic & Mixed Charge Organic Inhibitors for Hydrocarbon and Oxygen Corrosion Inhibitors for Produced Water
* Testing and Evaluation of Inhibitor and Biocide Effectiveness
* Safety Precaution in Working with Inhibitors and Biocides

Internal Corrosion Control as a Key Factor to Pipeline Integrity Management

* Hazard Assessment and Risk Based Inspection for the Pipeline and Equipment Maintenance Program
* Pipeline Internal Damage Record and Wall Thickness Monitoring
* Pigging for Water and Deposit Removal from the Pipeline System
* Controlling of Flow Stability and Corrosion Rate to a Safe Level
* Estimating Present Pipeline Remaining Service Life
* Evaluation of Present Condition and Comparison with Initial Pipeline Design Baseline
* Evaluation and Controlling of Chemical Inhibitor and Biocide Injection by using Corrosion Rate Monitoring Data.
* Evaluation of Pipeline and Equipment Damage in accordance with Root Cause Failure Analysis
* Development of Specific Pipeline Integrity Management System by using Internal Corrosion Rate Monitoring Data

METODE TRAINING

1. Presentation
2. Discuss
3. Case Study
4. Evaluation
5. Pre-Test & Post-Test
6. Games

Jadwal Diorama Training Tahun 2026

• Januari : 20-21 Januari 2026
• Februari : 24-25 Februari 2026
• Maret : 05-06 Maret 2026
• April : 23-24 April 2026
• Mei : 19-20 May 2026
• Juni : 23-24 Juni 2026
• Juli : 23-24 Juli 2026
• Agustus : 27-28 Agustus 2026
• September : 15-16 September 2026
• Oktober : 20-21 October 2026
• November : 17-18 November 2026
• Desember : 15-16 December 2026

Catatan: Jadwal tersebut dapat disesuaikan dengan kebutuhan calon peserta. Peserta dapat mengajukan tanggal pelaksanaan pelatihan. Sebelum melakukan booking tiket perjalanan maupun hotel mohon untuk menghubungi marketing kami terlebih dahulu. Kesalahan pemesanan tiket terkait jadwal tanpa surat konfirmasi (Confirmation Letter) bukan merupakan tanggung jawab tim Diorama Training.

LOKASI PELATIHAN

REGULER TRAINING

• Yogyakarta, Hotel Fortuna Grande Malioboro (6.000.000 IDR / participant)
• Jakarta, Hotel Amaris Kemang  La Codefin (6.500.000 IDR / participant)
• Bandung, Hotel Neo Dipatiukur (6.500.000 IDR / participant)
• Bali, Hotel Ibis Kuta (7.500.000 IDR / participant)
• Lombok, Hotel Jayakarta (7.500.000 IDR / participant)
• Surabaya, Hotel Neo Gubeng (7.500.000 IDR / participant)

ONLINE TRAINING VIA ZOOM

INVESTASI PELATIHAN

Investasi pelatihan selama tiga hari tersebut menyesuaikan dengan jumlah peserta (on call). *Please feel free to contact us.

Catatan: Apabila perusahaan membutuhkan paket in house training, anggaran investasi pelatihan dapat menyesuaikan dengan anggaran perusahaan.

Benefit Apa Saja yang Didapatkan Peserta?

• FREE Airport pickup service (Gratis Antar jemput Hotel/Bandara)
• FREE Transportasi Peserta ke tempat pelatihan (By Request)
• Module / Handout
• FREE Flashdisk
• Sertifikat
• FREE Bag or backpack (Tas Training)
• Training Kit (Dokumentasi photo, Blocknote, ATK, etc)
• 2x Coffee Break & 1 Lunch, Dinner
• FREE Souvenir Exclusive

FAQ tentang CVDIOR.CO.ID

P : Berapa minimal running pelatihan ini ?
J : Pelatihan ini akan running idealnya minimal dengan 3 peserta, tetapi bisa disesuaikan dengan kebutuhan peserta

P : Apakah bisa jika saya hanya ingin pelatihan sendiri aja / private course ?
J : Bisa, kami akan membantu menyelenggarakan pelatihan 1 hari jika ada persetujuan dari klien

P : Dimana saja pelatihan biasanya di selenggarakan?
J : Pelatihan kami selenggarakan di beberapa kota besar di Indonesia seperti Bandung, Jakarta, Yogyakarta, Surabaya, Malang, Bali, Lombok dan beberapa negara seperti Singapore dan Malaysia

P : Apakah bisa diselenggarakan selain di kota lain?
J : Penyelenggaraan pelatihan bisa diadakan di kota lain dengan minimal kuota 5 orang setiap kelas

P : Apakah bisa juga diselenggarakan secara IHT/ In House Training di Perusahaan klien ?
J : Bisa diselenggarakan secara IHT di Perusahaan klien

P : Apakah jadwal bisa disesuaikan dengan kebutuhan klien ?
J : Jadwal pelatihan dapat di sesuaikan dengan kebutuhan klien.

Materi, Lokasi dan Jadwal Pelatihan Bisa Berubah Sewaktu-waktu dan disesuaikan Dengan Kondisi Peserta, dimohon untuk Melakukan Konfirmasi untuk Segala Bentuk Perubahan, agar Tidak Terjadi Miskomunikasi. Segera Daftarkan Pelatihan, Dapatkan Promo Menarik Bulan Ini.